12413
Direct inquiry

Dear customers, partners and colleagues!

In this section you can send your message personally to the General Director of Rubex Group company.

Your inquiry will be considered within two working days.

Name*

Phone

e-mail*

Issue*

Message:

Rubber gaskets for hydraulic devices ТS 38.1051725-86

Rubex Group produces rubber gaskets for hydraulic devices, intended for clearance seal between the cylinder and the piston (plunger, ram), operating in conditions of in and out movement at a speed of conditional movement not more than 0,5 m/s, at pressure from 0,25 to 32 MPa (2,5-320 kgs/cm2), at temperature from – 60 to +100 °C. 

Rubber gaskets for hydraulic devices GOST 14896- 84

They are intended for clearance seal between the cylinder and the piston (plunger, ram) in hydraulic devices, operating in conditions of in and out movement at a speed of conditional movement not more than 0,5 m/s, at pressure from 0,1 to 50 MPa at temperature: for rubber group 2A- from -30 to +100 °C, for rubber group 6 – from -60 to +200 °С. Rubber group 2A is for work in water, water with potassium bichromate (no more than 1,5%), sea water, condensate. Rubber group 6 for work in oil-and-petrol resistant medium.

Chevron rubber-textile gaskets for hydraulic devices

They are intended for consolidation of piston rods and cylinders of hydraulic devices with a diameter of up to 2000 mm working under a pressure of up to 63 MPa at a speed of in and out movement up to 3 m/s in mineral oil, oil, fresh and sea water, water emulsions at temperature from -30 °C to +70 °C (short time up to 120 °C ).